How to reduce the loss of 532nm dpss laser cutting machine?
Aug 17 , 2021After a long period of use, laser cutting machines will inevitably have some loss. Once the degree of loss is too heavy, it will affect the service life and use effect of the equipment parts, which indirectly leads to poor cutting quality of the cutting machine equipment. So in the face of this situation, how to effectively reduce its use loss?
Before the laser cutting machine is turned on, push the beam to move forward and backward by hand. When you finish the work of the day, you should carefully clean up the waste and debris in the machine, so that the machine motion system can be prevented from being damaged by foreign objects. Clean up its moving parts to keep the machine in good working condition. The specific methods are as follows:
1. No items can be placed in the machine to avoid unnecessary damage to the machine.
2. Clean the dust and foreign matter on the metal oil tanker, metal shaft, sliding block and linear guide with cotton cloth, and then add lubricating oil, and carry out the reciprocating motion of the empty line.
3. Put a little lubricating oil on the screws, including the screws on the laser tube support and the reflector, which can facilitate the disassembly and assembly of the laser cutting machine during maintenance. Note: Do not add lubricating oil to timing belts, drag chains, air pipes, motors, sensors, lenses, and wires.
uv laser | green laser | Ultraviolet lasers | uv dpss laser | nanosecond laser | UV laser source | Solid State Lasers
So in general, if you want to effectively reduce the wear and tear of the laser cutting machine, you must do a good job in the lubrication and maintenance of each component, which can not only effectively reduce the wear and tear, but also reduce the failure rate and prolong the Its service life.
